Possible to rework it to erase 160D0WT?
1 – start machine with eeprom Adapter connected.
so when i try to write new mileage it write correct mileage with error.
also if i read the chip again it have the mileage that r270 wrote correct mileage.
so why error but it seam to write the file why??
1- read and save the original dump.
2- in the modification part you have to put the old km and new km, in the corresponding boxes and give it to change, make the bypass with the + 5v at the point that it indicates and wait for it to erase .. that it was writing . and work done.
2- with vvdi prog write original dump (don’t worry if it gives you error)
3- read ic and check all lines except 1 and 2 is correct write ( 1 and 2 if good is 00)
4- now in r270 read ic and change km old is 0 and new.. whatever you need
because i also managed to change mileage to on chip but all I tied end with an error but all lines looks correct so I have to test it on a dash.