CDDI Prog BMW MSV80 key programmer can program keys to BMW CAS1, CAS2, CAS3, CAS3+, FEM, BDC. Here, i will display how to use CGDI PROG BMW for F31 FEM remote programming.
Remote: 868
Chassis: F020
BMW F31 FEM
CGDI PROG BMW MSV80 key programmer
(this tool supports key matching and new key programming (when all keys are lost) of BMW CAS1, CAS2, CAS3, CAS3+, FEM, BDC)
The procedure:
Run CGDI PROG BMW software after finish all connection
Go to FEM/BDC key match
The current FEM BDC needs update the ECU program before performing key matching. Please ensure that the car battery has enough power. The programming process, please keep the equipment cable connection
Please remove the FEM BDC and then use the programmer to read and save data from the 95XXX EEPROM chip on FEM BDC computer board
Read the original car EEPROM data file
The 95128 EEPROM chip
CGDI PROG BMW is reading the chip data
Save data
Use the programmer (here we use Orange 5 eeprom programmer) to write the calculated new data to the 95XXX EEPROM chip , then put the FEM BDC back into the car
Write M95128
Check the FEM connection
FEM BDC test platform is on
Use the programmer to write the calculated new data to the 95XXX EEPROM chip , then put the FEM BDC back into the car
The ECU is being programmed…
Again, write M95128
Again, write M95128
Voltage test platform should be on
The FEM
Please remove the FEM BDC and then use the CGDI Prog programmer to write the original car EEPROM data back to 95XXX EEPROM chip and FEM BDC back into the car
Coding is successful!!!!
Job’s done.